Pricing

GENERAL INSPECTION (Pre-sale check over) (labor only):

  • Test battery using in-house battery analyzer, check charging system (bike must run), inspect engine for leaks, perform compression test( if accessible), ignition and spark plug check, inspect all safety items including lighting (headlight, tail light, brake light, turn signals and indicator lights), verify horn operation, check for proper operation of front and rear brakes, measure brake pad thickness, and check brake fluid level(s) and condition, check operation of clutch and clutch lever, check critical fasteners for tightness, test ride.
  • General Inspection: $90

MINOR INSPECTION SERVICE (oil, oil filter and lubricant included):

  • Removal and replacement of existing engine oil and oil filter, check/clean air filter, clean, lube and adjust chain, lubricate pivot points and fittings, check and adjust tire pressure to specification, clean bike prior to customer delivery.

Spectro Performance Oil 10w40 or 20w50 (up to 4 quarts) and K&N Filter: $148
Spectro Golden Synthetic Blend 10w40 or 20w50 (up to 4 quarts) and K&N Filter: $158

MAJOR INSPECTION SERVICE (labor only):

  • Make and model specific – contact for pricing

CARBURETOR CLEANING, RE-BUILDING, RE-JETTING/TUNING (parts not included)

  • Includes removal of fuel tank, push/pull throttle cables, choke cable, and all other parts associated with removal of carburetor structure. Disassemble each carb in order to access, inspect and clean the float bowls and needles, internal passages, the pilot and main jets, accelerator pump, and other necessary internal components. Re-assemble and re-install carbs synchronize. Does not include re-jetting.

Bank of four carburetors:   $350
Bank of three carburetors: $270
Bank of two carburetors:   $200
One carburetor:   $150

CARBURETOR RE-BUILDING/RE-JETTING:
Add $20 (plus parts cost) per carburetor to rebuild and/or re-jet. This price does not include the cost of on-bike tuning or synchronization.

TIRE CHANGE (tires/tubes not included):

  • Includes removal of wheel from motorcycle, dismounting old tire and disposal of tire, cleaning entire wheel, removal of old weights, mounting new tire (and tube if needed) in correct direction, inflating to spec, balancing new tire to wheel and re-installing.
  • ASK US ABOUT TIRE PRICING FOR YOUR FAVORITE BRAND! Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Spoke or tube installed wheels: $90 per wheel
Tubeless Wheel:  $65 per wheel
Deduct $30 per wheel for wheels brought in off-bike

COOLANT SERVICE (fluid included):

  • Includes flushing system with distilled water and solution, inspecting hoses and clamps, gasket surfaces, and components.  Filling system with distilled water and coolant solution to manufacturers standards and bleeding air from system.

Conventional liquid cooled motorcycle (up to 1 gal of coolant): $185

BRAKE FLUID SERVICE (fluid included):

  • Includes flushing circuit and fresh brake fluid. Inspection of all components and cleaning of the reservoir.
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Conventional fluid:  $100
Synthetic fluid:   $150

GEARBOX/TRANSMISSION/DIFFERENTIAL SERVICE (fluid included):

  • Includes draining of old fluid, inspecting fluid for any signs of problems, refill system with fresh specified fluid to proper level.
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Conventional fluid:  $100
Synthetic fluid:  $150

DRIVELINE SERVICE (parts not included):

  • Includes removing rear wheel, removing chain and drive sprockets. Cleaning of area and re-installation of replaced parts to manufacturers specification.  See adviser about our drive-line pricing!
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Conventional swing arm: $185
Single sided swing arm: $200

FRONT SUSPENSION SERVICE (parts not included):

  • Includes removal of front suspension, disassembly and inspection of components. Cleaning of all components and replacement of worn or questionable components. Re-install and fill with specified fluid to correct levels. Align front suspension.
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Conventional dampening rod suspension: $260
Inverted or “big piston” suspension:  $380

BRAKE PAD SERVICE (parts not included):

  • Includes removing braking components needed to replace brake pads.  Cleaning of all components, lubrication of needed areas. Measurement of disc/s for thickness and run-out.  Scuffing of rotors for proper re-seating.  See adviser for our brake pad pricing!
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Single disc: $120
Dual disc:  $150

BRAKE DISC REPLACEMENT (parts not included):

  • Includes removal of wheel to access disc, removal of disc from wheel. Cleaning of disc mounting surface and fasteners, and fastener holes. Installation of the new disc and fasteners with specified torque and/or solution. See adviser about our disc pricing!
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Single disc wheel: $120
Dual disc wheel: $160

VALVE CLEARANCE CHECK/ADJUSTMENT (parts not included):

  • Includes inspection of valve clearance and subsequent adjustment as needed. Inspection of cam timing system components and adjustment of any tensioners involved if needed.  Replacement of any gaskets or other seals that require attention. Provide owner specification sheet for records.
  • Prices may vary for special procedures or parts required from your manufacturer. See owners manual for details of your specific model.

Vintage:
Tappet style (up to 4 cylinders) : $120
Shim style (up to 4 cylinders) : $280
Desmodromic:  $280

Modern:
Standard shim style (up to 4 cylinders): $270
Super sport or super bike shim style (up to 4 cylinders): $320
Ducati 2v: $280
Ducati 4v: $350

SPECIFIC REPAIR, REPLACEMENT OR SERVICE ITEMS:

  • Battery Replacement (parts not included):  $45
  • Spark Plug Replacement : Call for specific pricing.
  • Lubricate all cables, (includes push/pull throttle cables, clutch cable, and choke cable: $40. If specific cables need replacement, extra parts and labor for each cable replaced.
  • Fuel Tank Draining and Re-Fill (labor and fuel included): $100 (includes up to 3 gallons of fresh 93 octane non-ethanol gasoline). If tank needs to be cleaned, or a pre-applied tank coating removed or replaced, the cost will be subject to prior approval by customer.
  • Petcock Replacement (labor and fuel included, parts not included): $100 (new fuel line and fuel filter will be provided with this service).
  • Points Ignition Service/Adjustment (parts not included): $90. Conversion to electronic ignition, add $200 (parts included).

Comments are closed